High End Systems Studio Command 1200, Руководство пользователя

Страница: 54 / 108

CHAPTER 3
The Menu System
44 Studio Command Series User Manual
Set an MSpeed Value (MSPD)
1. Scroll to the MSPD parameter. Press <Enter> to select.
2. Scroll to the desired MSpeed (in this example, 1.5) in decimal seconds.
3. Press <Enter> to store the selection.
Note: In this example, the MSpeed value only affects the pan and tilt
parameters, because the pan and tilt values default to MSpeed time,
and no other parameters with MSpeed values were chosen.
Choose a Macro (MACR)
1. Scroll to the MACR parameter. Press <Enter> to select.
2. Scroll to the desired macro value (in this example, MCOF).
3. Press <Enter> to store the selection.
Set a Crossfade Value (XFAD)
1. Scroll to the xFAd parameter. Press <Enter> to select.
2. Scroll to the desired crossfade value in increments of 0.1 or 1 (in this example,
x 1.5).
3. Press <Enter> to store the selection.
Note: The crossfade value will affect the DIM and ZOOM parameters. Set the
unit of time used for crossfade (seconds, minutes, or hours) using the
TIME parameter. Cyan, Magenta and Yellow are crossfaded in
continuous and pure mix modes that do not use MSpeed.
Set a Delay Value (DLAY)
1. Scroll to the dLAY parameter. Press <Enter> to select.
2. Scroll to the desired delay value in increments of 0.1 or 1 (in this example, d 6.0).
3. Press <Enter> to store the selection.
Note: The delay value determines the length of the scene. If you want all
motor transitions to be completed before the next scene begins,
XFAD or MSPD must be less than or equal to DLAY. If XFAD or MSPD
is longer than DLAY, the motor movement will not be completed
before the next scene begins, which could produce undesirable
results - such as no light output during the scene.
Set the unit of time used for delay (seconds, minutes, or hours) using
the TIME parameter.