High End Systems Studio Command 1200, Руководство пользователя

Страница: 19 / 108

Studio Command Series User Manual 9
Chapter 2:
Setup and Configuration
Unpacking the Fixture
Unpack your Studio Command
™
fixture and verify that it arrived
undamaged. Inspect both the outside of the fixture for physical
damage and the inside of the fixture for damage to glass
components.
To access the internal components, release the two bezel latches
(one latch located on each side of the fixture’s head) and remove
the bezel.
If the fixture is damaged, notify both the shipping agent and your
sales agent immediately.
Do not discard the shipping carton and packing materials. The carton and packing
materials are specifically designed to protect the product during transport.
High End Systems assumes no responsibility for products that are damaged during transport.
Always return a product for repair in its original shipping carton and packing materials.
Note: Before sending anything to the factory, call your High End Systems
dealer/distributor for a Return Material Authorization (RMA) number.
The factory cannot accept any goods shipped without an RMA number.
Installing an Attachment Plugs
Studio Command fixtures do not ship with molded attachment plugs on the fixture power cable
and, in the case of Studio Command-H fixtures, the dimmer power cable. Different locations
(even within the same country) may require a different attachment plug to connect your fixture
to a power outlet. Because of the variety of attachment plugs used worldwide, High End
Systems, Inc. cannot make specific recommendations for the particular attachment plug you
should use. Contact a local authority if you are unsure which type of attachment plug you need
to obtain. Note that the cores in the mains lead are colored according to the following code:
• green and yellow = earth
• blue = neutral
• brown = live
Removing the bezel
bezel latch