High End Systems studio color, Руководство пользователя

Страница: 39 / 114

Chapter 1 Installation and Setup 1-13
Introduction
Inst
allation and Set
up
1
Setting the Starting Channel by DMX Channel Number
To set the starting channel by DMX channel number, complete the following
procedure:
Caution: if an incorrect starting channel is given, channels could overlap and produce
unexpected results.
1. Apply power to the fixture.
2. Observe the display on the front of the fixture. Initially, it will display the
software version (
V x x x
) and then the fixture number (
F 0 1
).
3. Press and hold the <
MENU
> button until the display changes to
A d d R
.
Refer to Figure 1.12.
4. Use the up and down keys to move to the
S E T
field. Press <
ENTER
> to
enter the
S E T
field.
5. Use the up and down keys to move to the
C H N L
field. Press <
ENTER
> to
enter the
C H N L
field.
6. Use the up and down keys to move to the
D M X
field. Press <
ENTER
> to
enable the fixture to accept addressing by DMX channel.
7. Press the <
MENU
> key to back out to the
A d d R
(address) field.
8. Using the up and down keys on the front of the unit, set an the starting
channel from (
C 0 0 1
to
C 5 1 2
). Studio Color fixtures require 16 DMX
channels per fixture. Refer to Table 1.2 “DMX Starting Channel” on page
1-14 for assistance. The display will flash when it is moved from the stored
value.
9. Press the <
ENTER
> key to store the appropriate starting channel. The
display will stop flashing. The fixture address is stored in ROM and retains
its value until the value is changed.
Note: if <
ENTER
> is not pressed, the unit will not store the starting channel.
10. Press and hold the <
MENU
> button to exit the menu.