High End Systems intellaspot XT-1, Руководство пользователя

Страница: 26 / 98

CHAPTER 2
Setup and Configuration
12 intellaspot TM XT-1 User Manual
Connecting to the Link
To link one or more fixtures to a DMX controller:
1. Connect the male XLR connector of a DMX Data cable to the controller’s DMX Data Out
connector.
2. Connect the Data cable’s female XLR connector to the Data In connector of the first (or
next) fixture on the DMX link.
3. Continue linking the remaining fixtures connecting a cable from the Data Out connector of
each fixture to the Data In connector of the next fixture on the link.
4. Terminate the link by installing a 120 ohm, 1/4 watt (minimum) terminator in the fixture’s
Data Out (female) cable connector in the last fixture on each DMX link.
A terminator on the last
fixture of the link pre-
vents data reflection,
which can corrupt the
data communication on
the link.
Note: You can Address the fixture for DMX control using the Battery mode
before connecting to a power source, (see Setting a Start Channel in
Battery Mode on page 14) or in Normal mode, after powering up the
fixture.
Powering On the Fixture
To power on the intellaspot XT-1 fixture, simply connect it to a 100V-240V AC power source.
Once the intellaspot XT-1 fixture is connected to a power source, it automatically begins a
homing procedure to verify that fixture components are functioning.
WARNING:
This equipment is designed for connection to a branch circuit having
a maximum overload protection of 20 A.
CAUTION:
Do not power on the fixture until verifying that the line cord cap is
suitable for the power source in your location. For more information,
see
Installing a Power Cord Cap
on page 8.
Disengage Pan and Tilt locks before operating the fixture. For more
information, see
Pan and Tilt Locking
on page 7.
Do not unplug motor harnesses while unit is powered.
12
0
1
2
3
4
5
To construct a terminator:
1. Disassemble a male 5-pin XLR connector
2. Solder a 120 ohm resistor, minimum of
1/4 watt, between Pin 2 and Pin 3.
3. Reassemble the XLR connector.