High End Systems Dichroic Theatre Series, Руководство пользователя

Страница: 52 / 60

B-2 ColorCommand Installation Dichroic Theatre™ User Manual
6. The lamp assembly is connected to the fixture by lamp socket wires. Support the
lamp assembly while inserting the lamp. Do not allow the lamp socket wires to
support the weight of the lamp assembly.
7. Remove all packaging materials from the new
Philips 800W max lamp.
8. Holding the new lamp by its base, gently press
the two base pins straight into the lamp socket
until the lamp is firmly seated as shown in
Figure B-2.
Note: To avoid premature lamp failure, do not
touch the lamp glass. If you touch the glass,
clean the lamp glass carefully with rubbing
alcohol and a clean, lint-free cloth.
9. Gently replace the lamp socket housing on the reflector mount and tighten the
thumbscrews.
Caution: Improperly-installed lamps cause premature lamp failure and socket
problems.
Make sure the lamp socket wires are not wrapped around the lamp or
trapped while reinserting the lamp assembly.
Installing a Power Cord Cap
ColorCommand fixtures ships with a power cord without a cord cap. Different locations
(even within the same country) may require a different power cord cap to connect the
fixture to a power outlet.
Because of the variety of power cord caps used worldwide, High End Systems, Inc.
cannot make specific recommendations for the power cord cap.
Contact a local authority for the type of power cord cap needed. When installing the
power cord cap, note that the cores in the mains lead are colored in accordance with the
following code:
• green and yellow = earth
• blue = neutral
• brown = live
Warning: Class 1 equipment - This equipment must be earthed.
Installing a Line Cord Cap - U.K. Only
In the United Kingdom, the colours of the cores in the mains lead of this equipment may
not correspond with the colored markings identifying the terminals in the fixture’s plug.
Therefore, install a line cord cap in accordance with the following code:
Figure B-2 Installing the lamp