High End Systems Dichroic Theatre Series, Руководство пользователя

Страница: 36 / 60

3-4 Operation Dichroic Theatre™ User Manual
6. Press and hold the <Enter> button to select manual addressing.
7. Fixtures attached to the link, and their module address may be viewed by
pressing the UP & DOWN buttons to scroll through all attached fixtures. The
format is
# XX
, where
#
is the module address, and
XX
is the fixture type.
CM
=
ColorMerge,
CC
= ColorCommand
XX
= missing fixture.
8. The DMX start address of each fixture may be viewed by pressing the <Enter>
button.
9. To change the address of the selected fixture press and hold the <Enter> button
until the DMX start address begins flashing.
10. Scroll to the desired start address using the UP and DOWN buttons.
11. Press <Enter> to select the desired start channel.
Automatic Addressing.
Auto addressing automatically assigns DMX addresses to
fixtures attached to the link. Addresses are assigned sequentially starting with the
address immediately following the ColorPower Start channel. Each Dichroic Theater
product attached to the ColorPower is assigned an address according to its module
address and fixture type. ColorCommand fixtures require four channels, and
ColorMerge fixtures require three channels. After selecting
AUTO
, the attached
fixture types and their addresses are stored in an on-board EEPROM. Thereafter
ColorPower acquires its addressing information from this EEPROM. If fixtures are
added to the link after selecting AUTO, they will be assigned an invalid address. If
fixtures are removed from the link, they will be ignored. In either event, removal or
addition of fixtures will not change addressing, and thus will not change your show.
The auto address mode will not allow multiple fixtures to share the same DMX
address.
To use Auto addressing:
1. Press and hold the <Menu> button until
dMX
appears on the LED display.
2. Press the <Enter> button to enter the DMX menu system. The first option will
be
AddR
.
3. Navigate to the
ModE
menu by pressing the UP button.
4. Press the <Enter> button to enter the addressing mode. The first option will be
the
AUTO
addressing mode.
5. Press and hold the <Enter><Menu> button to select auto addressing.