b) Align the keyholes on the inner rail to the mounting pegs on the side of the enclosure and press the
inner rail flush against the chassis. If the keyholes don't line up with the pegs, flip the rail length-wise
to see if this will align them.
Figure 93: Inner Rail Attachment
c) Slide the inner rail toward the rear of the chassis to lock it in place. There will be an audible click and
the mounting pegs will cover the front part of the keyhole.
Figure 94: Slide Inner Rail
Click
Click
d)
Caution:
When installing the inner rail onto the chassis, make sure to only use the
special Low-Profile M4 x 3.2mm Philips screws provided in the accessory kit with the CMA.
These screws should be tightened to .90-1.12 Nm / 8-10 in-lbf using a # 2 Philips Screwdriver.
These screws are specially designed for this purpose. Using unapproved screws could cause
damage to the slides inside the rail.
94
4
Part Replacement
User Guide
4.8
Rails Replacement
