• Out-of-band management: Configuration 0 can be initiated to disable zoning in the out-of-band
management by using 0 in the ZoningConfig option. See:
for the actual senddiag
commands.
Figure 180: Configuration 0
There is no SAS cable connection Configuration table for this Configuration. This is because the host servers
do not rely on any order of connection to see the drives and drive slots.
Configuration 1:
Configuration 1 allows up to six redundantly configured hosts to view a specific zone group of drives. Each
host will be able to view up to 10 drives that are mapped to both IOMs. Each zone group will display all of the
devices that are contained within that zone. If a drive slot is not populated, it will still be part of that zone group,
but it will not display any results in enclosure management until the drive slot has been populated. In this
Configuration, the enclosure is divided into six zone groups as shown in the image below represented by six
different colors. Each zone group matches to a single SAS port on each side of the rear IOM to allow for the
connections to six different hosts.
• In-band management: Configuration 1 can be initiated in the sg_senddiag command in-band by using 01
in the Zoning Configuration option. See:
on page 168 for the actual senddiag
commands.
163
5
System Management
User Guide
5.2
Zoning
