10
!!! IMPORTANT !!!
Consider the following recommendations for positioning the control box:
•
Maintain a minimum distance of 3.5m between the control box and the edge
of the pool (norm NFC15/100) ;
•
Protect from the rain;
•
Protect from direct sunlight.
If the control box is connected to an outdoor electrical outlet, it must be approved for
outdoor use.
It is recommended to use a differential switch to connect the control box to the wall socket.
Always place the control box above the water level of the basin and any nearby basin or
water reserve, place it at least 30 cm above the ground. It is forbidden to place the control
box on the floor.
Make sure that there are no objects such as stones, branches, tools or toys are in the bottom
of the basin as they could prevent the program from being completed. Objects in the
bottom of the pool can get stuck in the SPOT PRO 100 vacuum robot.
Be sure to remove all objects on the surface (e.g., swimming lines) or at the bottom of the
pool (cages, underwater games, etc.) so as not to block the normal operation of the SPOT
PRO 100 vacuum robot.
Turn on the SPOT PRO 100 robot following the instructions. Be sure to keep your hands and
feet away from moving parts. Never place your hands or feet under the SPOT PRO 100
vacuum robot.
SPOT PRO 100 is suitable for cleaning pools up to 200 m² and operates in automatic mode
AQUA POSITIONING TECHNOLOGY, autonomously choosing the most appropriate
program, and in MODE MANUEL, controlled by radio control.
SPOT PRO 100 can also clean the walls of your pool. Very few cases make wall climbing
impossible: when radius of curvature is too narrow or when the wall tiles are slippery
because of micro- algae or other organic substances.
Dirt and debris tend to settle on the pool floor, climbing on the walls can sometimes be
considered as unnecessary: this function can be excluded at the SPOT PRO 100
programming, the robot will only operate on the bottom of the pool.
