HEUTE ProfilGate b55, Руководство по эксплуатации

Страница: 28 / 32

52
Fig. 56
Fig. 60
Fig. 57
Fig. 62
Fig. 58
Fig. 59
Fig. 63
Fig. 61
1.
Lift the grate completely out of the tray with two people.
1.
The fill level in the tray determines the amount of liquid that will
be transported through the bristles to the wheels and tires. A
default fill level is preset, however, it can be adjusted individually
and precisely. This is done with the aid of the adjustable overflow
plug.
2.
Remove the overflow plug to allow liquid to drain.
3.
With a high fill level, the “bristle feet” in the middle of the brush
strip (highest point) are in the water even without a load. This
provides for wetter contact surfaces, more intense cleaning, but
also more liquid carryover.
3.
Use a squeegee to let all liquid drain.
4.
Rinse the entire tray with clean water.
4.
In order to change the fill level, remove the overflow plug from
the drain and turn the pipe sticking out against the seal regula-
tor. Unscrew the pipe counter-clockwise to increase the fill level.
Screw in the pipe clockwise to lower the fill level. Test a new
setting and make sure that the tray does not overflow.
Complete cleaning ProfilGate® aqua
after grate removal
All ProfilGate® aqua models
Setting the fill level of ProfilGate® aqua
All ProfilGate® aqua models
2.
With a low fill level, the “bristle feet” in the middle of the brush
strip (highest point) will only enter the liquid during travel. This
provides for wet contact surfaces, good cleaning and low liquid
carryover.
www.nsltechnology.com