HETRONIC CS 434, Инструкция по эксплуатации и установке

Страница: 6 / 32

1.3. Sources of risk
The system is designed for permitting machines to be controlled by radio
remote control.
However, since the control commands also are transmitted beyond your range
of vision, and through or around obstacles in the vicinity, you should always:
- Put the transmitter down only in a safe and dry location, switch
the transmitter off and pull the key from the key switch (or if your
transmitter does not have a key switch, remove the rechargeable
battery or the battery compartment).
- Disconnect the power supply before you start any installation,
maintenance or repair work!
- Avoid removing or modifying any safety devices!
1.4. Qualified operators
(Refer to the operating instructions for the machine you intend to
operate with this control system!)
The operator is responsible for ensuring that when the transmitter is put down,
it cannot be used by unauthorized persons. This can be done either by pulling
the key from the key switch, by removing the rechargeable battery or by
storing the transmitter in a locked location.
The owner must:
- provide the operator with these operating instructions
and
- ensure that the operator has read and understood them.
1.5. Safety precautions in the working area
- Ensure that there is no risk of slipping in the work area.
- Before each use of the radio remote control system, check that
nobody is within the working area or swiveling range of your load.
- If a carrying aid is prescribed for your transmitter, this is to be
worn during use.
Either turn the key switch to the off position and pull the key, or
remove the rechargeable battery or the battery compartment from
the receptacle when putting the transmitter down. This will prevent
undesired use or misuse of the transmitter by third parties.