14
Assembly, Operation & Maintenance Instructions
STEP 01
/ Open the hood and fix the hood handle (14) using two M5x15mm screws (F), two
Ø5mm spring washers (C) and two Ø5mm flat washers (G). Tighten in place.
STEP 02
/ The hood and barbeque chassis assembly is transported screwed to the stand top by
four M6x20mm screws and four Ø6mm spring washers (two at the front and two at the
rear). Before attempting to build the stand, the stand top should be removed.
Angle the assembly slightly to the back and remove both M6x20mm screws, then do the
same at the front, supporting the parts so they don’t drop. Keep all of the fasteners for
later use. Removable stickers at the front and rear will mark the positions of these screws.
Remove the hood and barbeque chassis assembly from the stand top and place on the
ground.
STEP 03
/ Take the stand top (01B) and place it upside down (leg stumps up) on a clean surface
(note: there is no front or rear to this part). Take the right front leg (04 with a screw
hole in the foot) and slot it over the rear right corner stump. Fix in place using a M6 x
12mm screw (A) and flat washer (E), but do not tighten. Take the right rear leg (05 with
a screw hole in the foot) and slot it over the front right corner stump. Fix in place using a
M6 x 12mm screw (A) and flat washer (E), but do not tighten.
Take the left front leg (02) and slot it over the rear left leg stump. Fix into place using a
M6x12mm screw (A) and flat washer (E), but do not tighten. Take the left rear leg (03)
and slot it over the front right leg stump. Fix into place using a M6x12mm screw (A) and
flat washer (E), but do not tighten.
1 4
G
C
F
