.
21. Bend and test fit the throttle pushrod into position. Then remove from the fuselage until needed later.
22.
Glue one of the F-19 pieces into position. First, apply glue to the lower edge only and attach F-19 to the top edge of the
fuselage side. When the glue is dry, thoroughly wet F-19 with an ammonia based cleaner such as Sig’s Pure Magic
Airplane Cleaner and let it soak in for about 10 minutes.
23.
Now gently roll F-19 down into position
on formers F-7, F-15, and F-16. Hold in
this position until the moisture dries.
Mark F-19 at the centerline of the 3/16
sq. strip and trim with your hobby knife.
Now glue F-19 to F-7, F-15 and F-16.
24.
Now repeat this operation to install the
opposite F-19. Now set the fuselage
aside until needed later in construction.
Building the Wing
25.
Cut the lower 1/4 sq. main spar and the 1/16x1 trailing edge for the center section to length & pin into position on the plan.
26.
Glue the two lower plywood dihedral braces to the front and back of the lower spar.
27.
Cut and fit the forward and rear lower 1/16 sheet for the center section. The front piece is trimmed slightly long and is glued
to the front face of the forward dihedral brace. The rear piece is glued to the rear face of the rear dihedral brace and the 1
trailing edge.
28.
Glue ribs W-1 and W-2 into position on the lower spar and lower sheet. These ribs should be 90 degrees to the building
board. Glue the top 1/16 x 1 trailing edge into position.
29.
Glue the two tapered filler strips into
position between the top and bottom
trailing edges on either side of the center
W-1 rib.
30.
Glue part W-12 into position on top of
the lower 1/16 sheet and against the W-
1 and W-2 ribs.
