.
12. Gently squeeze the aft end of the
fuselage sides together and hold with
two clothes pins or a small clamp. Place
the formers F-11 and F-12 into position
and glue them to the fuselage sides.
Glue the aft end of the fuselage sides
together making sure that the joint is
straight and not leaning to the left or
right.
13.
Place part F-13 into position and glue it
to the center of formers F-6, F-11, and
F-12. Working from the front to the rear,
gently pinch the fuselage sides into
contact with F-13 and glue together.
14.
Place part F-14 into position and glue it
to the center of formers F-5, F-11, and
F-12. Now working from the front to the
rear, gently pinch the fuselage sides into
contact with F-14 and glue together. The
front end should rest on and be glued to
F-8.
15.
Glue F-9 to the forward bottom of the
fuselage between F-7 and F-8.
16.
Mark and drill 1/16 holes in F-7 for the
motor mount. Attach the motor mount to
the firewall with 4-40 screws and blind
nuts. Now install the motor on the
mount. The back of the muffler should
be 1/32 away from F-7.
17.
Mark and drill 3/16 holes in the firewall for the throttle pushrod, fuel, and vent lines.
18.
Glue the F-19 fuel tank support into position. Now assemble the fuel tank and install into the model. Cut the motor mount
screws off flush with the back of F-7 so they do not interfere with the fuel tank.
19.
Fit part F-18 to the fuselage and glue
into position and glue both F-20s into
position at the top of the fuselage sides
and the front of F-6.
20.
Glue parts F-10, F-15 and F-16 into
position at the nose of the model. Now
glue the 3/16 sq. strip into position
between F-7 and F-16.
