.
72.
Install the cowl on the model using the #2 sheet metal screws and securely attach the propeller.
73.
The wing struts are optional. They are installed using the following procedures. Sand the edges of the strut round. Bend one
of the strut wires and glue to one end of the strut.
74.
Cut the plastic strut tube into four 1/4 lengths. Mark the strut locations on the model using the plan as a guide. Carefully
remove a 1/16 x 1/4 strip of covering at the tube mounting locations. Now glue the strut tubes to the model.
75.
Mount the wing on the model. Attach the
strut to one of the wings by sliding the
wire into the tube. Now swing the strut
against the fuselage side and cut it off so
that there is about 1/8 between the end
of the strut and the tube on the fuselage.
Now attach the lower strut wire to the
strut. Build the other strut and finish
them with covering material.
76.
Balance the model at the location shown on the plan. If necessary, add weight to the nose or tail until the model is balanced
with the fuel tank empty. Set the control throws to the measurements shown on the plan and verify that the controls move in
the proper direction.
77.
Always pre-flight your model thoroughly before each flight. It is your responsibility to verify that your model is airworthy.
Always follow established safety guidelines and manufacturer s recommendations while starting and operating the engine,
radio, and when flying the model.
WARRANTY
Herr Engineering Corp. guarantees this kit to be free from defects in both materials and workmanship at the
time of purchase. This warranty does not cover any component damaged buy use or modification. In no case
shall Herr Engineering Corporation's liability exceed the original cost of the purchased kit. Further Herr
Engineering Corp. reserves the right to change or modify this warranty without notice.
In that Herr Engineering Corporation has no control over the assembly or use, no liability shall be assumed or
accepted for any damage resulting from the use by the user during construction of the kit or the use of the final
user assembled product. By the act of building this kit and/or using the final user assembled product, the user
accepts all liability.
If the buyer and/or user is not prepared to accept all of the liability associated with this product, he is advised to
immediately return this kit in new and unused condition to the place of purchase for a full refund.
© Copyright SIG Mfg. Co., Inc.
SIG MFG. CO., INC............Montezuma, Iowa 50171-0520
LIMIT OF LIABILITY:
In use of our products, Sig Mfg. Co.'s only obligation shall be to replace such quantity of the product proven to be defective.
User shall determine the suitability of the product for his or her intended use and shall assume all risk and liability in connection
therewith.
