Operating Manual
Page 31
not required anymore for this level. The access code is only requested again when the
parameter level is changed
7.1.4. Password Error Message
The following message is displayed on the screen if
differences between the entered and the saved
access code have been established when a password
has been requested.
7.1.5. Measurement Parameters
Although the next setting menu can be viewed
through operating ENTER it is protected against
changes. The status of protected pages is signaled
through a little lock in the left-hand top corner.
While working in this mode, the access code is constantly requested, even when working on
one and the same level.
The configuration data and the reset functions are also protected with access codes per the
same principle.
A calibration cannot be carried out without an access code.
7.1.6. Use of Master Code
If access protection is cancelled using the master
code, this lack of protection is indicated by a key and
explanation mark in the last row of the display
screen.
The lack of protection icon can only be removed by confirming the original access code.
7.1.7. Reset
Performing a reset will reset all configuration parameters for all channels. Insure that you
know all configuration parameters for this controller before performing a reset.
The reset function can be used to rectify possible sporadic malfunctions of the E-CO Lineguard
97 Controller through restarting the E-CO Lineguard 97 Controller or resetting measuring
modules to their initial state.
The key combination , , and ENTER in the measuring screen must be operated for 5
seconds in order access the reset menu. The following options are then displayed.
