Operating Manual
Page 11
Modules are supplied with mounting hardware to mount them inside the control panel.
Relay Module with Mtg. Hardware
Relay Module Pins
The Relay Module is supplied with (3) plastic Standoffs and (3) screws.
Install the standoffs into the threaded holes in the motherboard.
Install the Relay Module, after installing the standoffs, by carefully inserting the pins into
the socket on the motherboard.
When installing the modules pay special attention to the pins on the back side of the
module. These pins must be carefully aligned and inserted into the sockets on the
controller motherboard.
After Relay Module is seated into the socket on the motherboard, insert screws thru the
module boards and thread into standoffs to secure module in place.
Do not over tighten the screws, the plastic components can strip out and break very
easily.
Control modules will be installed into the Module 1, Module 2 and Module 3 positions on
the motherboard. The control modules are supplied with one stand off and one plastic
screw to secure it into place.
If there is only one control module installed, the module will need to be installed in
“Module 1” location. There always needs to be a module installed in this location for
proper operation of controller.
Additional modules can be installed in the remaining locations, as required.
Install the standoff into the treaded hole on the motherboard.
When installing the control module, carefully align the pins on the back of module with the
sockets on the motherboard. Press into place to seat properly.
When installing the modules pay special attention to the pins on the back side of the
module. These pins must be carefully aligned and inserted into the sockets on the
controller motherboard.
Install plastic screw, near center of the module and thread into the standoff.
Do not over tighten the screws, the plastic components can strip out and break very
easily.
Once all required modules are installed and power is applied to the panel, initial set up will
need to be made to configure proper language, measurement units and initial settings for the
controller. Initial setting suggestions can be found in on the following pages.
RELAY MODULE PINS
