5
EN
Main parts of the appliance
1. Pipe holder
2. Fountain pipe
3. Auger
4. Silica gel ring (Ø 24mm)
5. Air-proof ring (Ø 20mm)
6. Base unit
7. FUSE housing
8. Motor / Heater switch
9. Power connector
10. Temperature adjuster
11. Heat dissipation hole
12. Motor axle
13. Seal ring (Ø 220mm)
14. Chocolate pool
1
2
4
5
6
7
8
3
10
11
12
13
14
9
Putting the appliance into use
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier
immediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Place the appliance on a level and steady surface,
unless mentioned otherwise. Two of the three
feet of the base unit can be adjusted in height to
level the appliance.
• Do not place the chocolate fountain near an air-
conditioning duct, open door or window. Cool air
will solidify the chocolate and stop the evenly flow
of chocolate.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
• Unpack the chocolate fountain.
• The packaging contains a base unit, a chocolate
pool, a fountain pipe, a pipe holder, a auger, a seal
ring, five silicon seal rings. five air-proof rings
and two fuse(thermal cut-out).
• Keep the packaging if you intend to store your ap-
pliance in the future.
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
• Place the seal ring [13] on the top of round edge
of the base unit[6].
• Screw in the chocolate pool [14] on the base unit
by clockwise.
• Place the auger[3] on the motor axle[12] of the
base unit.
• Place the fountain pipe[2] over and cover the au-
ger[3] and screw in the fountain pipe[2] on the
base unit[6] by anti-clockwise.
• Place the pipe holder[1] on the top of fountain
pipe[2] and line up the center hole with the top
of auger[3].
• The chocolate fountain is now ready for use.
