VARIO-PERGOLA
INSTALLATION INSTRUCTIONS
Helioscreen Australia Pty Ltd
Page 15
Art.-Nr.: 930059 © by
WO&WO
Literal mistakes and technical changes excepted
Valid from February 2010
Page 14
InstallatIon InstructIons
Pergoline
7.
annex
For adjustments of the driving gear, please refer to the “Driving gear adjustment” sheet.
The XLINE
shading system requires the adjustment of both driving gear end positions. A failure to set the driving
gear end positions can lead to an impaired function of or damages to the system. (the use of a driving gear with
electronic torque-activated cut-off mechanism is not permissible).
a.
aDjuStment oF the Driving gear enD PoSition
b.
alignment oF the Fall bar
Measure the distance between the fall bar and the rail end
on both sides.
The correction is made on the side that extends further.
Remove countersunk screw (1) with SW 4mm Allen key and
take off plastic cover (2). Get hold of the end of the strap (5)
with your hand or a tool and do not let go.
Loosen counternut (3) with SW13mm ring spanner.
Loosen the threaded pin (4) with SW 4mm Allen key.
Now give pulling strap enough rope so that the fall bar
moves to the correct position.
Then slightly tighten threaded pin (4) and lock with nut (3).
Wind up protruding tape and stow away in the cover. Fit
cover and fasten with countersunk screw.
If the fall bar is parallel, the fabric tension should be roughly
the same on either side.
3
5
4
2
1
7. ANNEX
7.1. ALIGNMENT OF THE FALL BAR
Measure the distance between the fall bar and the rail end
on both sides.
The correction is made on the side that extends further.
Remove countersunk screw (1) with SW 4mm Allen key
and take off plastic cover (2). Get hold of the end of the
strap (5) with your hand or a tool and do not let go. Loosen
counternut (3) with SW13mm ring spanner. Loosen the
threaded pin (4) with SW 4mm Allen key. Now give pulling
strap enough rope so that the fall bar moves to the correct
position. Then slightly tighten threaded pin (4) and lock
with nut (3).
Wind up protruding tape and stow away in the cover. Fit
cover and fasten with countersunk screw.
If the fall bar is parallel, the fabric tension should be roughly
the same on either side.
