VARIO-PERGOLA
INSTALLATION INSTRUCTIONS
Helioscreen Australia Pty Ltd
Page 12
Valid from February 2010
Literal mistakes and technical changes excepted © bei
WO&WO
Art.-Nr.: 930059
Page 11
InstallatIon InstructIons
Pergoline
•
Fix the post profile on the post’s base plate.
•
For this purpose, turn the threaded pins in the groove nuts
through the drillings onto the peg of the post’s base plate
and tighten firmly.
•
Fix the post’s base plate with the appropriate fixing
materials on the base.
•
Connect a test cable to the system and
extend approximately 20cm.
•
Connect the guide rails with the pegs of the
casing using the countersunk screws.
3. line SyStemS
To install line systems, at first mount all boxes and
only then proceed with the guide rails and posts as
described for the individual systems.
Before inserting the end cap of the centre guide rail as
described in 2.8, it is necessary to fit the second pulling
strap with the pulley.
•
For the installation, pull the fall bar of both systems on
the side of the centre guide rail approximately 100mm
in extended direction with the pulling strap, and then
insert a screwdriver between the fall bar and the casing
to prevent the fall bar from retracting.
•
At the end cap of the centre guide rail, loosen
countersunk screw (1) with an SW 6 Allen key and
remove including the interior sleeve (2). Take out the
deflection pulley (3) and place pulling strap over it.
•
Place the pulley with the pulling strap in the end cap
(ensuring that the pulling strap is not twisted!). Insert the
sleeve with the chamfer of the bore pointing towards the
screw head. Firmly tighten the countersunk screw.
•
Now remove the strap securing clips (4) and proceed
according to 2.8.
Chamfer
3. LINE SYSTEMS
• To install line systems, at first mount all boxes and
only then proceed with the guide rails and posts as
described for the individual systems.
!
• Before inserting the end cap of the centre guide rail
as described in 2.8, it is necessary to fit the second
pulling strap with the pulley.
• For the installation, pull the fall bar of both systems on
the side of the centre guide rail approximately 100mm
in extended direction with the pulling strap, and then
insert a screwdriver between the fall bar and the
casing to prevent the fall bar from retracting.
• At the end cap of the centre guide rail, loosen
countersunk screw
(1) with an SW 6 Allen key
and remove including the interior sleeve (2). Take out
the deflection pulley (3) and place pulling strap over it.
• Place the pulley with the pulling strap in the end
cap (ensuring that the pulling strap is not twisted!).
Insert the sleeve with the chamfer of the bore
pointing towards the screw head. Firmly tighten the
countersunk screw.
• Now remove the strap securing clips (4) and proceed
according to 2.8.
