VARIO-PERGOLA
INSTALLATION INSTRUCTIONS
Helioscreen Australia Pty Ltd
Page 14
5. DISMOUNTING THE AWNING
!
• Ensure that the area around the awning is free of unauthorised personnel.
• Dismount the awning exclusively in retracted condition.
• Dismounting of the awning is the reverse of the mounting procedure.
6. TROUBLESHOOTING
TYPE OF DEFECT
CAUSE
REMEDY
Driving gear does not work
No power
Check connection (specialised company)
Driving gear not correctly connected
Check connection (specialised company)
Thermal protection of the driving gear activated
Wait for 15-20 mins, then operate again
Remote control batteries empty
Check light signal on sending unit, replace
batteries
Higher-level control unit prevents manual
operation
Wait until higher-level signal is not activated
any more.
Driving gear does not work
End positions of the driving gear changed, or
incorrect end position setting
Reset or re-program end positions (see Driving
Gear Instruction Manual)
System does not close on one side
Thickness of the tapes differs
In retracted condition, apply textile tape
backing to the pulley on the side on which the
system does not retract sufficiently. Extend
system and achieve parallel fall bar alignment.
Awning fabric sags unevenly
Not the same number of windings on the pulley
Check number of strap windings on the pulley
and equalise.
Fall bar parallelism changed or incorrectly
adjusted.
Reset fall bar parallelism (see Annex)
When operated, system moves by jerks
and jolts or generates indefinable noises
Rail parallelism or rectangularity changed
Reset rail parallelism or rectangularity
(see item 2.9.)
Foreign bodies or lots of dirt in the channels of
the guiding rails
Clean guiding rails and spray lubricant on
the rollers of the fall bar
