Heli-Max AXE CX Nano, Инструкция по эксплуатации

Страница: 20 / 28

20
Replacing the Main Gear
The AXE CXn uses an inner solid main shaft and a hollow outer main shaft. To
access the main rotor gears it will be necessary to remove the landing gear
fi rst. Remove the lower main gear retaining screw. The lower gear will simply
drop down off the main shaft. If you need to replace the upper main gear,
slide it down off the main shaft and reinstall the new gear, ensuring that the
fl at spot molded inside the gear aligns with the main shaft. Reinstall the lower
gear, ensuring that the screw aligns with the fl at spot machined on the inner
main shaft.
Replacing the Main Shaft
The AXE CXn uses an inner solid main shaft and a hollow outer main shaft.
Remove the lower main gear retaining screw. When performing the following
step please be careful not to lose any small bearings or bearing blocks. Slide the
inner shaft and upper rotor head from the outer main shaft by pulling upwards.
If you need to remove the lower shaft, disconnect the servo linkages from the
swashplate and pull upwards. Transfer necessary parts from the old shaft to the
new shaft and install in the reverse order listed above.