Heiko Thermal 12, Руководство пользователя

Страница: 11 / 132

1. Before use
Copper Steel
Fuse
Main
Power Cable
RCD
Indoor
control
unit
If the supply cord is damaged, it
must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order
to avoid a hazard.
It is mandatory to use a suitable
circuit breaker for the heat pump
and make sure the power supply to
the unit corresponds to the
specifications. Otherwise the unit
might be damaged.
Disposal of Scrap Batteries ( if
there is ). Please discard the
batteries as sorted municipal waste
at the accessible collection point.
An all-pole disconnection device
which has at least 3mm clearances
in all poles , and have a leakage
current that may exceed 10mA,
the residual current device (RCD)
having a rated residual operating
current not exceeding 30mA, and
disconnection must be incorporated
in the fixed wiring in accordance
with the wiring rules.
ON
OFF
Please select the correct fuse or
breaker as per recommended. Steel
wire or copper wire cannot be
taken as substitute for fuse or
breaker. Otherwise, damages
maybe caused. Be aware fingers might be hurt by
the fin of the coil.
11
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources.
To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
System water filling
T/P valve
Connect to heating/cooling system
Buffer tank
Connect to heat pump
One way valve
Filter
City water inlet
1. It's suggested to use pure water for filling the system.
2. If use city water for filling, please soften the water and add a filter.
Note: After filling, the system of water system should be 0.15~0.6MPa.