made for garden
31 / 82
PL
SK
DE
EN
CS
TIPS FOR SNOW CLEANING
• Snow cleaning do as soon as finished falling snow, later lower layer gets icy and is difficult to
clean it.
• The snow direction keep if possible in the same direction as wind.
• While working proceed so that the tracks of snow thrower were overlapped.
• In windy conditions, lower the chute deflector to direct the discharged snow close to the
ground where it is less likely to blow into unwanted areas.
• Clear area of debris. Be sure that the area is clear of stones, sticks, wire or other foreign objects
which could be accidentally thrown out by the machine or wrapped around the rotating parts.
It may cause serious personal injury to the operator and others as well as damage to property
and surrounding objects.
• Work with the machine only on safety surface. Do not work on stone or gravel surfaces –
danger of machine damage and flying stones.
• Do not overload the capacity of the appliance by attempting to clear snow at too fast a rate.
The forward speed of the snow thrower is dependent on the depth and weight of the snow.
Experience will establish the most effective method of using the snow thrower under different
conditions.
CLEANING THE MACHINE
As soon as you finish the work, remove from the machine all the rests of snow. The rests of snow
can get frozen in the machine and the machine will be overloaded, moreover the frozen pieces
of snow and ice could be thrown away. While cleaning, repairs, adjusting, servicing and when
you leave the machine always switch off the engine and disconnect the connector of spark plug.
CLEANING OF STOPPED SPIRAL OR THROWING TUNNEL
Danger of injury. Before each operation on the machine switch off the engine and
let stop all the rotating parts.
Pull off the ignitions key (or switch in OFF position) and disconnect the connector of spark plug.
The chute clean-out tool is conveniently fastened to the rear of the auger housing with
a mounting clip (fig. 19A). Should snow and ice become lodged in the chute assembly during
operation, proceed as follows to safely clean the chute assembly and chute opening.
Warning: Never use your hands to clear a clogged chute assembly.
SNOW CHAINS (ADDITIONAL EQUIPMENT)
For extreme snow and weather conditions is possible to purchase snow chains under order No.
009551. If you do not know how to fit the chains, contact your dealer.
MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free operation.
WARNING! Improper maintenance, or failure to correct a problem before operation,
can cause malfunction in which you can be seriously hurt or killed. Always
follow the inspection and maintenance recommendations and schedules in this
owner’s manual.
