made for garden
30 / 82
PL
SK
DE
EN
CS
For extreme cold operating conditions press 1x to 3x primer (fig. 16A). Making sure to cover
vent hole when pushing. If the engine is warm, push the primer only once. Cool weather
may require priming to be repeated.
Important: Do not use the primer or the choke if the engine has been running and is
hot. Excessive priming may food the engine and prevent it from starting.
For cold start push the choke lever (fig. 16C) to 1 position CHOKE (ON)
. When starting
warm engine leave choke lever on RUN position
.
Turn the switch (fig. 17A) to “ON“ position.
Pull the starting rope till you feel resistance (fig. 17B). Then pull strongly and evenly. Starting
rope hold firmly and let slowly rewind.
Choke adjustment: When the engine starts to run, get choke lever slowly back to position 0/
RUN. Before each movement of the lever wait till the engine speed gets stable.
After starting let the engine run 1 – 3 minutes at low speed, in the meantime check the
engine condition, if it is running steadily or if you cannot hear unusual noise. Then adjust the
speed by throttle lever to required level.
STOPPING THE ENGINE
Having finished the work let the engine run for few minutes to let evaporate humidity and
melted snow and ice and the machine is dry for next use.
Throttle lever push to „Turtle“ symbol.
Switch turn to OFF position.
Fuel valve turn to OFF position.
In case of long operation break (after season) is recommended to mix additive to fuel as
a prevention of fuel deterioration and problems with restarting in the beginning of next
season. Do not use the fuel which is older that 14 days.
DRIVE GEARS
Shift the gears only when the coupling is switched off (machine stands still and
only with the engine switched on).
Change gears by means of gear lever (fig. 18A).
Forward: 1 – slow, 4 – quick
Reverse: R1
Before shifting gear check if the snow thrower is not blocked.
TIPS AND CAUTIONS FOR OPERATING
WORKING IN THE SLOPE
Danger of injury by overturning machine. Work always slowly and pay high attention. Lead the
machine always up and down, never work horizontally or sideways in the slope. The machine
could lose balance and overturn. The machine must not be operated in slopes over 20%. Avoid
overturning machine – danger of fatal injury.
