HeatStar HSSVFBF10LPT Скачать руководство пользователя страница 3

3

Installation Instructions and Owner’s Manual

Unvented Liquid Propane Fired Room Heater

DANGER

: Carbon monoxide poisoning may lead to 

death. 

Carbon Monoxide Poisoning:

Early signs of carbon monoxide poisoning resemble 

the flu, with headaches, dizziness, or nausea. If you 

have these signs, the heater may not be working 

properly. Get fresh air at once! Have heater serviced. 

Some people are more affected by carbon monoxide 

than others. These include pregnant women, persons 

with heart or lung disease or anemia, those under the 

influence of alcohol, and those at high altitudes.

Propane/LP Gas:

Propoane/LP gas is odorless. An odor making agent is 

added to propane/LP gas. The odor helps you detect 

a Propane/LP gas leak. However the odor added to 

propane/LP gas may be present even though no odor 

exists. Make certain you read and understand all 

warnings. Keep this manual for reference. It is your 

guide to safe and proper operation of this heater.

Product Features

Figure 1

PRECAUTIONS:

1. 10,000 BTU may be installed in a bedroom, but not 

a bathroom, or any place where a strong wind would 

shut down the appliance.

2. This heater needs outside ventilation air to run 

properly. The Oxygen Depletion Sensor (ODS) safety 

shutoff system shuts down the heater if not enough 

fresh air is available. See 

Fresh Air for Combustion 

and Ventilation

, page 5.

3. Keep all air openings in heater clear, free of debris 

or any blockage. This will insure that enough air for 

proper combustion enters the heater.

4. If heater shuts off, do not relight until you provide 

fresh, outside air. If heater keeps shutting off, it 

requires servicing.

5. Turn off and let cool before servicing. Only a qualified 

service person should service and repair heater.

6. Do not run heater:

• 

Where flammable liquids or vapors are used or stored

• 

During dusty conditions.

7. Before using furniture polish, wax, carpet cleaner or 

similar products, turn heater off. If heated the vapors 

from these products may create a white powder 

residue within burner box or on adjacent walls or 

furniture.

8. Do not use heater if any part has been underwater. 

Immediately call a qualified service technician to 

inspect the room heater and to replace any part of 

the control system and any gas control which has 

been underwater.

9. Operating heater above elevations of 4,500 feet 

could cause pilot/ODS to shutdown heater.

10. Always run heater with control knob in a locked 

position. Never set control knob between locked 

positions. Poor combustion and higher levels of 

carbon monoxide may result if control knob is left 

between locked positions.

Control Knob

Grill

Front Panel

Burners

Heater 

Cabinet

**Operating heater above elevations of 4,500 feet could cause pilot/ODS to shutdown heater.**

SPECIFICATIONS

MODEL

HSSVFRD10LPT

HSSVFBF10LPT

BTU (Available) 

10,000 

10,000 

Type of Gas 

LP-Gas Only 

LP-Gas Only 

Ignition 

Electronic Pulse (AA Battery) 

Electronic Pulse (AA Battery) 

Pressure Regulator Setting 

10 Inches of Water  

10 Inches of Water

Inlet Gas Pressure (Maximum) 

14 Inches of Water 

14 Inches of Water

Inlet Gas Pressure (Minimum) 

11 Inches of Water 

11 Inches of Water 

Burners / Orifice nozzles 

2  

1

Thermostatic Control 

Yes

Yes

Clearances: inches (mm) 

  Top 

36” (915cm) 

36” (915cm) 

 Sides 

10” (254cm) 

10” (254cm) 

  Floor (min. to top of carpet) 

3” (76cm) 

3” (76cm) 

  Fabric / flammable objects 

36” (915cm) 

36” (915cm) 36” (915cm) 

Содержание HSSVFBF10LPT

















Отзывы: