Figure 4.8 Backplate dimensions (in mm)
Pipe Entry
4.9 Available entry points:
Top, bottom, rear and right hand side (bottom is generally the easiest). The inlet spigot
is smooth, 15mm diameter and is designed to accept a 15mm compression fitting. This must be an elbow for top,
bottom and rear entry, and a straight connector for side entry. (See
Fig. 4.9
) You should use compression rings
(olives) made of copper, rather than brass, as copper will crush down better onto the plastic spigot. Push-fit
connectors cannot be used.
21/03/2011
www.partsarena.co.uk/baxi/System/DA…
partsarena.co.uk/baxi/…/I47-2835.htm
10/16
