09-02
27
30532 Rev D
NASIM REAR DIRECT VENT DECORATIVE GAS APPLIANCE
4. CLEANING THE GLASS
See Figure 47.
Never operate this appliance without the glass properly
secured in place or if the glass is broken or chipped.
5. LOG REMOVAL/REPLACEMENT
If removal of the logs becomes necessary, remove the two screws at each
side of the front log. Grasp the front log. Pull the log toward the front and up,
off the burner. See Figure 48.
To replace the logs, grasp the front log. Lower the log set so that the back
log rests on the shelf in the back of the firebox and the two tabs behind the
back log are inserted into the slots in the back of the firebox. Replace the
two screws removed earlier at each end of the front log.
Figure 48 - Log Removal
Figure 47
Glass Cleaning
Safety Note:
Handle glass with care to
avoid striking, scratching
or slamming shut. Never
clean glass when it is hot.
Keep children and pets a
safe distance away.
In the event of glass breakage, carefully remove the screen
and glass frame. This will allow the removal of all glass
fragments and sheet metal edge protection strips. Vacuum
all remaining glass pieces with a shop vac.
DO NOT VACUUM IF PIECES ARE HOT!
Replace glass with only a Heatilator Glass Panel Assem-
bly ordered direct or through your local distributor. Never
use substitute material. Only fully tempered soda lime
safety glass may be used on this appliance.
All manuals and user guides at all-guides.com
