01-03
19
34613 Rev F
NOVUS SERIES INSTALLATION INSTRUCTIONS
4. ASSEMBLING THE SLIP SECTIONS
Slip sections should be snapped into the first mating
piece, then expanded to their desired length, making
sure that a 1.5 overlap is maintained between the
two sections of the slip section. The two sections of
the slip section then need to be secured by driving
two screws through the overlapping portions of the
vent. See Figure 36. This will secure the slip section to
the desired length and prevent it from separating. The
slip section can then be attached to the next section of
vent.
5. DISASSEMBLING VENT SECTIONS (only
if necessary)
To disassemble any two pieces of pipe, simply rotate
either section so that the seams on both pipe sections
are aligned as shown in Figure 37. They can then be
carefully pulled apart.
Figure 36
Figure 37
