6
Classic 9800
Installation Instructions
Cut hole in cabinet to mount oven. Cutout in cabinet
should be level and straight.
NOTE: There are no provisions to level the unit after it is
installed. An oven that is not level could cause poor baking
results.
Install plywood floor as shown on page 7 or 8 for floor
installation.
Remove oven door(s). See Oven Door Removal
procedure.
Attach unit to the cabinet with four No. 8 x screws
supplied with unit inside of envelope containing these
instructions. Pre-drill holes in cabinet for attachment
screws using /8 drill. Oven mounting holes are
provided in side trim.
Install bottom trim.
Replace oven door(s). See Oven Door Replacement
procedure. (page 9)
See instructions at right for electrical hook-up.
See Use and Care Manual for operating instructions.
Installing Bottom Trim Piece
Remove lower screws from hinge
receptacle plates. Align lower trim
and reinstall screws.
DO NOT INSTALL BOTTOM TRIM UNTIL UNIT IS ATTACHED
TO THE CABINET.
WARNING
Improper installation of the grounding circuit can result in
a risk of electric shock.
Consult a qualified electrician or service technician if the
grounding instructions are not completely understood, or if
doubt exists as whether the appliance is properly grounded.
.
2.
3.
4.
5.
6.
7.
8.
Electrical Connections
Electrical hookup must be performed by a licenced
electrician
3.6kW@ 240 Volts 60Hz
A licensed Electrician must be used to hardwire house
unit to a junction power supply box. A power supply
junction box must be mounted in the cupboard below
the unit in a wall mounted installation or in the cabinet
adjacent to in an undercounter installation. Once the
appliance is in place, secure power supply box.
Stove must be electrically grounded in compliance with
local codes. In the absence of local codes, refer to the
National Electrical code ANSI/NFPA 70 “Latest Edition”
in the US or in Canada with the Canadian Electrical
Code, Part I, CSA Standard C22, or the Local National
Electrical Code.
Interrupt the source of electricity to the unit when
attempting to repair or service the oven. Failure to do
this could result in a dangerous or even fatal shock
CAUTION
For European style cabinets (flush front) the required
clearance for operation of the oven door is minimum
spacing of 7/8 between the cutout and the door, hinge or
drawer of the cabinet.
Some built-in cabinets may not be wide enough, due to
their construction, to allow this installation.
Important: Save these installation
instructions for local electrical
inspector’s use.
•
•
•
•
•