HDG K10, Руководство по эксплуатации

Страница: 30 / 64

4 Planning and installation – Installing the heating system
30
1. Remove the insulation (1) above the cleaning shaft lid.
2. Release the star-grip screw (2).
3. Lift off the cleaning shaft lid (3).
4. Break out the perforation (1) on the rear wall.
5. Remove the insulation around the (2) flue gas casing.
6. Cut the cable ties (3) on the fan cable.
7. Undo the four hex socket screws (1) in the cleaning shaft lid.
8. Carefully take off the flue gas housing.
9. Turn the flue gas housing (3) by 90° and screw it on again.
10. Put the insulation (2) back in on the left (enclosed, on the side
below the flue gas housing).
✓
The flue gas connection gas been converted.
Figure 4/12 - Opening the cleaning shaft lid
1 2
3
Figure 4/13 - Removing the rear wall
1
2
3
Figure 4/14 - Turning the flue gas housing
1
2
3
Important!
The seal between the flue gas housing and the boiler must not be
damaged.