HCO
5-Advanced Setting SG550/SG530
Page 20
4.1.12
Restoring Default Setting
The camera can be restored to factory default setting by following steps:
1
In MENU, press the UP or DOWN key until Default Set appears, as shown in Fig.
16(a) and 16(1).
2
Press the OK key to restore default settings or press the MENU key to cancel and
exit. After pressing the OK key, the camera will be back to factory default settings
(see Table 1). Fig. 16(b) shows the information after you press the OK key.
(a)
(1)
(b)
Figure 16: Load default settings
4.2 Playback and Editing
There are two ways to playback or edit picture or video:
•
Computer
You can take the SD card out of the camera and use a card reader to view or edit the
picture and video. Or, you can connect the camera directly to your computer in which
case the camera works as a card reader.
•
TV or Picture Viewer (such as a digital picture frame)
You can also connect the camera to a TV or other picture viewer to view or
edit the picture or video. Note that the stand-alone operations of playback and
deleting can only be done in the TEST mode. The following instructions demonstrate
how to use TV or other picture viewer to view picture or video.
Playback
1.
Connect a TV monitor or a Picture Viewer (such as a digital picture frame) to the
camera through the video cable (comes with the camera). It should be connected to
