HB-CL2
Cleaning Unit
Operation
O8305-EN 2022-01
57
8.1.2.5 Preservation phase
In this phase the connected components are treated with the
preservation agent, in order to protect them and avoid rusting
during stprage- At the end of the preservation phase the connected
components are emptied again.
Fig. 30: Preservation setting
The preservation phase is either carried out automatically, omitted
or queried depending on the setting of the
preservation
parameter.
The preservation parameter is set as follows:
1.
Display the menu page
Settings \ Miscellaneous
.
2.
Set parameter
Preservation
to the desired value.
With the setting OFF, the preservation phase is omitted,
with the setting ON, the preservation is started automatically
and with the setting Query, it is being asked whether the
preservation phase should be started or not.
Add preservation agent
Fig. 31: Example add preservation agent
Proceed as follows if the warning
Add agent
is displayed:
1.
Acknowledge horn with the
key.
2.
Fill indicated pre-preservation agent quantity in through the
tank opening in the tank.
WARNING!
Risk of injury due to chemicals!
Chemicals can cause chemical burns, depending
on the type and dilution, cause irritation of the
membrane and respiratory system and be toxic if
swallowed.
Therefore:
– Only allow work on with chemicals s to be
carried out by qualified personnel.
– The general safety instructions on how to
handle chemicals according to the safetydata
sheets must be observed at all times.
– Do not mix chemicals
3.
Acknowledge after adding of preservation agent the query
with the
key.
Preservation time
If necessary, before switching on preservation, set the desired
preservation duration:
1.
Display the menu page
Settings \ Cleaning
.
2.
Set parameter
Preservation time
to the desired value.
