Installation
–Valve Actuator Ports
(Jandy AquaLink)
If an open actuator port is not available, or more than 4 speeds is needed, one of the existing ports
being used can be piggybacked in some situations. The wiring for this tie-in is shown below. Care
needs to be taken to ensure that the speed being used corresponds with the use of the actuator, since
both will be activated simultaneously .
To Actuator
(All work performed must be done
with power disconnected to the
controller and pump)
Run to Step 1, 2 or 3 as needed
AC
Voltage
Note that the center
wire only goes to
the actuator and
not the pump
Page 13
Incoming 230 VAC to Pump
