Installation
–Valve Actuator Ports
(Jandy AquaLink)
Shown below, on the Jandy AquaLink, are the cleaner and solar sockets with plugs installed. These
sockets in many installations are not being used and would be open.
Speeds are set in the TriStar VS timers menu, times are set in the controller.
(All work performed must be done with power disconnected to the controller and pump)
Intake Return Cleaner Solar
For this illustration, Actuator
pigtail GLX-ACT-CONN will
need to be obtained.
Incoming power
AC Voltage
Note: Use the two outside wires of the actuator
and cap the center one. In most cases the
center wire is red.
Page 12
