USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
1-888-HAY-INDL (1-888-429-4635)
ISHCP3000FC Rev A 11/30/16
Pg. 9 of 16
www.haywardflowcontrol.com
Hayward Flow Control
Wiring
WARNING
–
All electrical wiring MUST be in conformance with all applicable local codes, regulations, and the
National Electric Code (NEC). Refer to motor nameplate for wiring diagram.
WARNING
–
3 Phase motors are not thermally protected. Motor thermal overload protection must be provided by
installer.
Pump MUST be permanently connected to circuit. If other lights or appliances are also on the same circuit, be sure to add
their amp loads before calculating wire and circuit breaker sizes. Use the load circuit breaker as the Master On-Off switch.
WARNING
-
Risk of dangerous or fatal electrical shock. Be sure that power to the motor circuit is off before
working on wiring, wiring connections, or motor. Re-install the motor end cover and all other wiring covers before turning on
the power.
To Wire a Single Speed, Single Voltage Motor
1. Turn off power.
2. Remove the motor end cover.
3.
There are two terminals labeled L1 and L2. Attach the power leads to these terminals. Either wire may attach to
either terminal.
4.
Reinstall motor end cover.
WARNING
-
If you do not use conduit when wiring motor, be sure to seal wire opening on end of motor to prevent
dirt, bugs, etc., from entering.
