33
c. Trimmer Head
1)
Keep the trimmer head clean and free of debris.
Remove
trimmings.
2)
If the line is used up the spool must either be replaced
by
one of the same type or the trimming line must be
refilled.
3)
To refill the trimming line lay the product on a flat stable
surface with its trimmer head facing upwards.
4)
Rotate the backing flange until one of the notches is
aligned with the hole in the gear head.
5)
Insert the spindle lock rod into the hole to lock the
spindle.
6)
Remove the trimmer head by unscrewing clockwise.
7)
To replace the spool simply remove from the trimmer head
and replace with a new one of the same type.
8) To replace the trimming line, press the release latch of the
trimmer head housing to open the cover.
9) Cut a new 6 m long trimming line with a diameter of 2 mm.
Form a loop at the middle of the line and insert this loop into
the hook on the spool.
10) Wind the two parts of the trimming line in clockwise
direction firmly around the spool each part in the guide on the
spool.
11) Insert each end of the threads in the respective holes. The
threads should stick out 150 mm on each side.
