24
Move the choke lever to the “ ” position, do not press the
primer.
Hold the product stable and pull the recoil starter handle
firmly; repeat until the engine starts. Allow the recoil starter
rope to return slowly and controlled after each pull!
WARNING! Make sure that the cutting blade is
not touching the ground or other objects when
starting the product!
3. Control
•
Press the throttle interlock, hold it in position and then
press
the throttle trigger to engage the attachment.
•
Release the throttle trigger, this tool will be set at idle
speed
status.
4. Stopping
•
Release the throttle trigger and let the product run at
idle
speed for 10-15 seconds.
•
Set the ignition switch to its off position "STOP".
WARNING! The attachment will continue to move
for some time even after the engine has been
switched off! Wait until the attachment has come
to a complete stop before placing the product on
the ground!
5. general behaviour
•
Check the product as well as accessories for damage
before each use. Do not use the product if it is damaged or
shows wear.
•
Double check that accessories, safety guards and blades
are properly fixed.
•
Always hold the product the product by its handles. Keep
the handles dry to ensure safe support.
•
Ensure that the air vents are always unobstructed and
clean. Clean them if necessary with a soft brush. Blocked air
vents may lead to overheating and damage the product.
•
Switch the product off immediately if you are disturbed
while working with it and when other people enter the working
area. Always let the product come to complete stop before
putting it down.
•
Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control over
the product.
