32
NOTE: Remove the branches lying on the floor regularly to
avoid stumbling hazards. Check the oil level regularly and
fill up if necessary. Switch the power off and disconnect
from power source when leaving the product.
12. After Use
•
Switch the product off, allow the engine to cool down and
then remove the spark plug connector.
•
Check, clean and store the product as described below.
Care and Cleaning
WARNING! Always switch the product off, let the product cool down and disconnect
the spark plug connector before performing inspection, maintenance and cleaning
work!
WARNING! Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified specialist!
WARNING! Wear safety gloves when working on the attachment heads and close to it!
Use appropriate tools to remove debris, e.g. a brush or wooden stick! Never use your
bare hands! Keep the product clean. Remove debris from it after each use and before
storage. Regular and proper cleaning will help ensure safe use and prolong the life of
the product. Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts.
a. General cleaning
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents or disinfectants
to clean this product as they might be harmful to its surfaces.
1) Clean the product with a slightly damp cloth and mild soap. Use a brush for areas that are hard to
reach.
2) In particular clean the air vents after every use with a cloth and brush.
3) Remove stubborn dirt with high pressure air (max. 3 bar).
4) Check for worn or damaged parts. Replace worn parts as necessary or contact an authorised
service centre for repair before using the product again.
b. Blade (Brush Cutter)
1) Keep the cutting blade (B5) clean and free of debris. Remove clippings.
2) Keep the cutting blade (B5) sharp to retain a good cutting performance. Replace a worn or
damaged cutting blade with a new one of the same type.
