Pocket Hole Jig
A
x1 Pocket Hole Jig
B
x 1 Long Torx T20 Pozidrive bit (Code
503457)
C
x 1 M2 Hex shank step drill bit and ring collar
clamp
Step 1
Measure the width of the timber, see
picture above.
Step 2
Line-up the machined groove
(a)
with
the numbered scale
(b)
to match the timber
thickness. See the “Drill Guide Block Chart”
to set the correct height. Lock the block in
position using the two threaded locking pins
(c).
Step 5
Attach the drill bit to the drill,carefully
insert the drill bit into one of the bushing guide
holes, start the drill, using stage cutting for
adequate chip clearance until the ring collar
(C) is flush against the bushing guide. (See
diagrams below) Repeat for the remaining hole.
A
C
C
B
Step 3
Place the ring collar clamp
(C)
over step
drill bit shaft, inset the drill bit into the bushing
guide hole, raise the drill bit so it’s (2-3mm)
above the base plate and tighten the ring
collar flush against the bushing guide.
DO NOT
OVERTIGHTEN!
Step 4
Clamp the timber against the guide
block by pushing the lever handle forward,
making sure the timber is clamped square
and firm. If there is too much pressure or not
enough, pull back the lever handle and rotate
the threaded adjuster on the clamp shaft and
try again. Repeat the procedure until correct.
(See diagrams below)
Continues Over...
What’s Included
Operating Instructions
Adjuster
Work bench
mounting hole
Lever handle
Base plate
Clamp
Locking
Pin
Thickness guide
Guide block
Bushing guide
2-3mm
Code 503726
Date: 21.09.2022
a
c
Timber Thickness
USE
13 -17mm
12mm
18-23mm
18mm
24-29mm
24mm
30-35mm
30mm
36+mm
36mm
Drill Guide Block Chart
NOTE: SET THE CORDLESS
DRILL TO HIGH SPEED!
3mm Hex key
Base plate
C
b
English
Version
