6
TECHNICAL DATA
ENGLISH
ASSEMBLY
Observe correct mains voltage: The voltage of the power source must match
the voltage specified on the nameplate of the unit.
1. Place your handle on the tool as shown(Fig.5).
2. Adjust handle to the most comfortable position.
3. Pass the handle knob bolt through auxiliary handle. Screw the handle knob
bolt into the captive nut on the far side of the auxiliary handle(Fig.5).
4. Adjust the forward or backward to a comfortable position; tighten knob
securely.
Product code
Model number
Input voltage rating
Rated current
No load variable speed
Cutting width
Cutting line diam. and length
Net weight
59595078
N1F-GT-250/3.0-C
120 V~, 60 Hz
3 AMP
12 000 RPM
10" (250 mm)
0.055" x 19.6'
3.1lbs (1.4 kg)
Assemble the auxiliary handle
Advice
1. Place unit on a flat surface.
2. Push the upper half frame into the lower one each other as the following
picture, until they are tightly connected(Fig.3&Fig.4).
Assemble the unit
N
O.
!
WARNING!
Ensure during assembly that the power cable is not squeezed and
that it has sufficient play.
Fig.3
Fig.4
Fig.5
