9
OPERATION
ENGLISH
Check length of nylon cutting line (Fig.16)
1) Pull line (6) to inner edge of outer guard (8). If the line is too short, i.e. more
than 50mm from inside edge of guard, push down on centre of trimmer head
(5) and at the same time pull the line a few centimeters past the edge of the
guard.
2) Remove trimming blade guard (9).
N
O.
!
Note:
Only remove trimming blade guard (9) when all operation checks have been
carried out.
Store trimming blade guard (9) after replacing new nylon cutting line. When the
trimmer starts, the line will automatically be cut to the correct length
Fig.13
Fig.14
Fig.15
Fig.16
4) Along the groove slide the string into the hole in the string cover. (Fig.13)
5) Prepare to assemble the spool into the trimmer.
Third
How to assemble the spool
1) Insert the spring into the shroud and thread the string into the hole as shown
in Fig.14.
2) Place the spool cover (3) on the spring and press it firmly down until the
locking devices (4) of the spool cover (3) securely click into place. (Fig.15)
