Haulotte H12 SD, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 55

8
1.5. CHECKS.
These must comply with the national regulations in force in the country of use.
For Australia : Australian Standard AS 1418.10 – 1996 and AS 2550.10 – 1994.
1.5.1. periodic checks.
Machine must undergo periodic checks. Details of the checks are covered in the relevant sections of this
manual.
1.5.2. Examination of machine suitability.
The site supervisor at the location where the machine is placed into service must ensure machine is suitable,
i.e. capable of performing the work in complete safety, and in compliance with the instruction manual.
1.5.3. State of Conservation.
Inspect for any deterioration that is liable to cause hazardous situations (check safety devices, load
restrictors, tilt sensor, cylinder leaks, deformation, welds, bolt tightness, hoses, electrical connections, tire
state, excessive mechanical clearances).
NOTE: If machine is rented, the renter is responsible for carrying out visual inspections of the machine as
well as confirming the machine suitability for the work to be performed. Full details of the inspections are
covered in the relevant sections of this manual.
1.6. REPAIRS AND ADJUSTMENTS.
Repairs and adjustment including any adjustments to safety systems or device, mechanical, electric or
hydraulic must be performed by a competent person. Replacement parts used must be Haulotte standard
parts in order to ensure that warranty conditions for the machine are honoured by Haulotte. The use of non-
standard parts will void the warranty.
Any modification to the machine must be authorised in writing by and inspected by Haulotte to avoid rejection
of any subsequent warranty claim.
1.7. CHECKS BEFORE RETURNING UNIT INTO SERVICE.
To be performed after:
•
a major stripping operation,
•
a repair concerning critical machine components.
•
an accident caused by critical component failure.
It is necessary to perform a “state of conservation” examination, a stability (static overload) test and a
functional (dynamic) test. See § 5.4. in the maintenance section of this manual. These tests must be
performed by a competent person.