Haulotte Group OPTIMUM 1931 E, Книга по эксплуатации

Страница: 53 / 148

53 4000429690 E 11.15 US / GB
General data
Structural part inspection
MS0001
3.3 - F
UNCTIONAL TESTS
The following tests must be carried out each 250 h or 6 months or afterwards :
• An important technical intervention.
• An accident resulting from a failure of a major component.
The following tests must be realized by a qualified staff under secure conditions.
The results of the tests must be entirely documented.
To avoid the swing of the machine during the test, it is imperative that a device of reserve (chain, not of
anchoring) is used during the test.
3.4 - D
YNAMIC TESTS
The machine must be place on level and firm ground.
With 100 % of the maximum allowed load, operate from ground control box (or emergency control box) all
the movements.
The functional tests must show the following facts :
• The machine carried out all the movements without jolts while supporting the load.
• All the security device function correctly.
• Authorized maximum speeds of operation are not exceeded.
Refer to the user manual for the description of the safety device and technical characteristics to be reached.
3.5 - S
TRUCTURAL TEST
(O
VERLOAD
)
The following test shows that the structure of the machine is in conformity with the safety requirements.
The machine must be place on level and firm ground.
With 125 % of the maximum allowed load, operate from ground control box (or emergency control box) all
the movements :
• Measure the distance between the ground and the basket (or of the platform).
• Leave the machine in static during 15 mnn.
• Measure the distance between the ground and the basket (or of the platform).
If the difference between two measurements does not exceed 4 cm (1.575 in) : the test is validated.
If the difference between two measurements exceeds 4 cm (1.575 in), to contact HAULOTTE Services®
or to carry out the additional tests described below.
MS0003 - § 3.2 Cylinder inspection.