Hatco GLO-RAY GRSSR20-DL Series, Инструкция по установке и эксплуатации

Страница: 7 / 16

Form No. GRSSRDLM-0607
5
INSTALLATION
UNPACKING
The Glo-Ray ® Round Heated Stone Shelf with
Display Lamp is shipped pre-assembled and ready
for operation. Care should be taken when unpacking
shipping carton to avoid damage to unit and
components enclosed.
WARNING
To prevent any injury or damage to the unit do
not pull unit by power cord.
WARNING
To prevent any injury, discontinue use if power
cord is frayed or worn.
1. Remove unit from box.
2. Remove information packet. To prevent delay in
obtaining warranty coverage, fill out and mail
in the warranty card.
3. Remove protective paper from all surfaces before
placing into service.
LOCATION
NOTE: Unit must be transported in the upright
position.
For proper operation and maximum performance,
locate the Glo-Ray Round Heated Stone Shelf with
Display Lamp in an area where the ambient air
temperature is constant and is a minimum of 70°F
(21°C). Areas which are susceptible to active air
movements or currents should be avoided, i.e., near
exhaust fans or hoods and air conditioning ducts.
CAUTION
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a minimum
of 70°F (21°C) and a maximum of 85°F (29°C).
WARNING
For safe and proper operation, the unit must
be located at 1" (25.4 mm) distance from
combustible walls and materials. If safe
distances are not maintained, discoloration or
combustion could occur.
CAUTION
To avoid any injury or damage locate the unit at
the proper counter height, in an area that is
convenient for use. The location should be level
to prevent the unit or its contents from
accidentally falling, and strong enough to
support the weight of the unit and food.
WARNING
To avoid any injury or damage to the unit(s)
connect to a properly grounded electrical
supply. Contact a qualified electrician to
determine the proper voltage, wire size and
installation method.
WARNING
The Glo-Ray Round Heated Stone Shelf with
Display Lamp must have a minimum of 1" (25 mm)
clearance along the sides of combustible walls
and materials. If safe distances are not
maintained, discoloration or combustion could
occur.
Figure 5. Minimum Clearance from Combustibles
1" (25.4 mm) 1" (25.4 mm)