Hasselblad H4X, Руководство пользователя

Страница: 22 / 84

22
H4X
Film tab holder I
Holds an ID tab from the film roll pack as a reminder of the type of
film loaded. Don’t forget to change it if you change film type!
Film holder key J
Secures the film holder in the magazine. Fold out the key and turn
counter­clockwise 90° to remove the film holder and turn clock­
wise 90˚ to lock the film holder in place.
Magazine settings lock K
All settings can be locked to avoid inadvertent changes. To change
the settings, slide the settings lock (see illus) to the right until it
stops. After the changes have been made, slide the settings lock to
the left (see symbol on magazine) again to secure the new settings.
Databus interface L
Data interface between magazine and camera. Ensure the contacts
are kept clean and protected from damage. Keep the protective
cover on when the magazine is being stored or transported.
Operation
Battery
The magazine uses a battery to retain information and settings
when unattached from the camera. When attached to the camera
body, the magazine takes its power requirements from the cam­
era batteries. The magazine battery will normally be effective for
1­2 years depending on use (off camera illumination, for example).
When the battery is in a very low condition, (approx. 1 month of
use left), a low­battery symbol appears on the magazine LCD as a
warning. The magazine will continue to function with no battery
power left as long as it remains attached to the camera body. How­
ever, when detached, the settings will not be stored.
Battery replacement 1, 2
Release the film holder by folding out the film holder key and
rotating it 90° in a counter­clockwise direction. Withdraw the film
holder completely. On the bottom plate on the inside of the film
magazine housing you will find a slotted circular battery cover.
Insert a small coin or similar into the slot and rotate the cover
about 20° in a counter­clockwise direction. The cover will be freed
and the battery can be removed. Replace with a fresh CR2032 / 3V
lithium (or equivalent) battery. Observe the polarity and ensure
the positive (+) face is uppermost and replace the cover (ensure
the retaining lugs are inserted in the battery compartment slots),
locking it into place by rotating it in a clockwise direction until it
stops. If you inadvertently insert the battery incorrectly, the film
magazine will not be damaged though it will not function. Try to
avoid touching the surface of the battery with your bare fingers
as sweat residue can decrease the electrical conductivity of the
battery casing and might cause corrosion.
After battery replacement, the magazine’s parameters return to
the default settings (Barcode, 120, Data­on, Count up).
K
I J
L
2
1