25
H4D
4
Carrying strap
1, 2
The carrying strap is attached by firstly withdrawing the safety
collar. The hook is then freed and attached to the strap lug (fig. 1).
Slide back the safety collar (fig. 2) to ensure the hook remains in
the locked position between the small protruding lugs. The collar
is purposely a tight fit and might need some effort to slide.
Rechargeable battery grip
The Battery grip rechargeable 7.2V (3043348) is the standard
power source for the H4D camera and is an environmentally
approved Li-ion type. The H4D requires a power supply for all ac-
tions as there is no mechanical reserve facility. When working un-
tethered, it is therefore advisable to keep a reserve rechargeable
battery grip at hand. As is the case with most batteries, problems
might be encountered when used in very low temperatures. In
this situation it is advisable to keep the reserve battery in an in-
side pocket, for example, to maintain it near body temperature
(both sorts of battery grips are referred to as the ‘battery’ in this
manual).
Fitting and removing a battery
3, 4, 5
The fitting and removing procedure is the same for both types of
battery grip.
Remove the battery from the camera by depressing the battery
holder button (A) and simultaneously swinging the battery hold-
er retaining lever (B) down until it stops. Pull the battery down-
wards (C).
If you intend to store the battery separately from the camera you
should ensure that the safety cover is in place (to prevent short-
circuiting). It snaps into place and is removed by pulling outwards
and upwards on the locking clip (fig. 4).
To fit, hold the battery flat against the camera body and aligning
the two upper lugs with the slot, slide it back into position as far
as it will go. Swing back the battery holder retaining lever until it
clicks back into place.
The battery charger
6, 7
The battery charger unit is supplied with five plug attachments to
suit various types of domestic electrical sockets available world-
wide. Other types of socket will require a domestic socket con-
verter. Attach the chosen plug (fig 7) by sliding it into position,
ensuring that the two electrical contact prongs on the charger
correctly enter the two contact sockets on the plug attachment.
Removal is by the reverse procedure.
Please note the Battery charger BC-H Li-ion 7.2 VDC (3053568)
is designed for use with Battery grip rechargeable 7.2V units only.
7
1
2
1
A
B
C
3
5
6
