HARWI ORCA 1850, Руководство пользователя

Страница: 24 / 79

24
FITTING THE MAIN SAW-BLADE
0 An end switch is mounted in the cover of
the saw-unit. If after changing the saw-
blade the cover is not closed properly the
motor will not start.
1
Disconnect mains supply.
2 Open the cover of the saw unit.
3 Insert the delivered 8 mm allen key in
the saw spindle.
4 Loosen nut with flat key SW 30
(Fig. 23).
5 Remove front flange.
6 Remove saw-blade.
7 Check if front and back flange are clean.
8 Put the new saw-blade on the spindle.
See to direction of rotation .
9 Put flange, washer and nut back again
Notice: A key is fitted in the spindle to
prevent turning of the flange.
Check presence of key and see to it that the
flange is pushed over properly.
10 Check the adjustment of the riving knife.
11 Close lid of the safety guard.
12 Connect mains supply.
Notice:
Speed has to be mentioned on the
saw-blades;
Min. rpm N = 5.000 for the main saw-blade.
Min. rpm N = 15.000 for the scoring blade.
Fig. 23