HARWI ORCA 1850, Руководство пользователя

Страница: 36 / 79

36
DIGITAL READ OUT (OPTIONAL)
ADJUSTING FROM THE TOP SIDE OF THE
MATERIAL
1
Put the saw unit in horizontal position
(Fig. 38)
2
Fasten the motor carriage with the knob
at the right side at the top of the panel.
3
Smoothen the panel at the top side.
4
Press button .
The digital read out shows an off-set
value of -3,2 mm (Fig. 40).
Notice: the off-set value equals the loss of
the saw incision.
5
Loosen the knob of the motor carriage
and adjust the needed width.
6
Fasten the motor carriage and cut from
left to right (see chapter horizontal
cutting).
7
Press button to reset to the off-set
value of -3,2 mm.
ADJUSTING OFF-SET VALUE
Frequently check the off-set value (= the
width of the cut in the material). If there is
any deviation re-adjust.
1
Measure the width of a test cut in the
material.
2
Press the F-button for 3 seconds, the
digital read out shows: ConF.
3
Press several times shortly the F-button
until the display shows P 28.
4
Press one more time the F-button, the
digital read out shows the current off-set
value.
5
Use the and button to change the
value.
6
Press several times shortly the F-button
until the digital read out shows the
normal measuring again.
Fig. 40