HARWI ORCA 1850, Руководство пользователя

Страница: 38 / 79

38
DIGITAL READ OUT (OPTIONAL)
RE-ADJUST THE REFERENCE POINT OF THE
MIDWAY FENCES
Re-adjust the reference point when bottom
supports are smoothened or when the
midway fences are smoothened.
Check the reference point when battery is
replaced.
1
Check if the reference point of the bottom
supports is correctly adjusted.
2
Disconnect the machine of the mains
supply.
3
Put the saw unit in horizontal position.
4
Press the F-button for 3 seconds, the
digital read out shows: ConF.
5
Press several times shortly the F-button
until the display shows P 24.
6
Press the F-button one more time.
7
Use the and button to change the
value to 000000.0
8
Press several times shortly the F-button
until the digital read out shows the
normal measuring again.
9
Position the saw blade on the midway
fences.
10
The digital display shows a value. Write
this value down on a piece of paper.
11
Press the F-button for 3 seconds, the
digital read out shows: ConF.
12
Press several times shortly the F-button
until the display shows P 24.
13
Press one more time the F-button, the
digital read out shows 000000.0
14
Use the and button to change the
value to the value that was written down
on the paper.
15
Press several times shortly the F-button
until the digital read out shows the
normal measuring again.
STANDARD VALUES
Press three seconds the F-button to check
the standard values. Press shortly the F-
button to go to the next value.
Designation Display Programmed
value
Saw direction ConF 0
mm-inch /
Counting dir. P 01 01
Decimal point P 03 1
Factor P 08 1.0000
Reference ABS P 09 Ref value
Reference MF P 24 Ref value
Off-set value P 28 000003.2
Version P 99 0005.103